Method of use for methanol and ethanol rapid detection instrument (operating specifications for methanol and ethanol rapid detection instrument)

Usage of methanol and ethanol rapid detector:

1. Prepare the blank solution and sample solution according to the steps in the reagent manual;

2. Place the [sample solution] colorimetric dish into the corresponding channel, click the sample name button, and select [sample name]

3. Detection

① Put the blank solution into channel 1, place the sample solution in channels other than channel 1, and click on the methanol ethanol rapid detector to directly measure the number.

② Place the blank solution into channel 1, place the sample solution in channels other than channel 1, adjust the reaction time according to the reagent instructions, click on the detection progress bar, and the methanol ethanol rapid detector will display the detection result.

4. Save (manually save)

5. Printing (manual printing)

Operating specifications for methanol ethanol rapid detection instrument

Operating specifications for methanol and ethanol rapid detection instrument:

Before using the methanol ethanol rapid detector, it is necessary to correctly install the battery, sensor, etc. according to the product manual, and read the user manual to familiarize oneself with the meanings of various buttons and screens. The testing environment for enclosed panel houses and buried trenches requires air sampling to provide reference measurement samples before use.

When using a methanol ethanol rapid detector for various tests, it is necessary to operate the detector correctly and refer to the possible causes of faults listed in the user manual for troubleshooting. Strictly follow the working conditions of the methanol detector to avoid safety accidents and unnecessary waste caused by careless operation.

When using a methanol ethanol rapid detector for detection, the sensors and detection instruments should be kept clean, accurate, and securely connected to the terminal network. After testing, alcohol should be used to clean the surface of the sensor and detector, and attention should be paid to storage temperature, regular calibration, and other logistical requirements.